Things You’ll Need Modem. Click here Step 2. You will have to experiment a bit to learn which device is which based on their IDs. Then it will act just like an Ethernet switch to provide the extra Ethernet ports that you need. If you are unsure, leave it as the default

Uploader: Melkree
Date Added: 24 December 2017
File Size: 14.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 30789
Price: Free* [*Free Regsitration Required]

This is not information you should be sharing.

All replies Drop Down menu. Once logged into your router click on the “Wireless” tab.

Linksys WRT160Nv2 Wireless MAC Filter

By default ‘Basic Wireless Setting’ should be chosen, if not click it now. Answer this question Flag as Mar 7, 6: When setting up or changing liinksys wireless settings it is a good idea to be plugged into the router with your network cable and not your wireless connection. Wrt610n am out of wired connections to the Time Capsule and I have poor connection speed in my office, so I am looking to connect my old router Linksys WRTN V2 using the cable that is available on the third floor so that I have better wireless connectivity on linksus third floor and additional hardwire ports available.


User profile for user: Warnings Do not upgrade the firmware of the router unless you know what you are doing.

Re: Linksys WRTN v2/Mac issues – Linksys Community

Wireless Speciality level out of ten: Router Networking Devices In other languages: Disable UPnP as there are vulnerabilities with this feature. You may wet160n forward a range of ports by using the Port Range Forwarding sub-tab. Leave the username blank and enter “admin” for the password. You don’t want to be wirelessly configuring the router. Test My Port Forwarding. For the more advanced user, you may block specific applications such as Telnet and POP3 email.

Enter the wanted password into both Router password slots. I have wrt160b several discussion forums, but I have not had any luck finding a solution.

Wireless Setup – Linksys – WRT160N v2 (Linksys Firmware)

If your configuration is correct, your Mac or PC will automatically switch to the wireless access point with the strongest signal as it “roams” about the house. Linksys sets the default to http: Tips You may have to reset linksya Router to factory settings by pushing a pin in the small hole in the back of the router while its powered up.

Notice that the configuration has two options: Click here Step 2. Here are some steps to help you configure it.


This article has also been viewedtimes. You can do a factory reset on the unit by powering it off, holding down the reset button with a pen or other pointed object, and holding down for about 15 seconds while you power back on. This may cause the router to stop functioning linksyd. This is done by typing the IP address of the router.

Thank you for your feedback!

Wireless Setup – Linksys – WRTN v2 (Linksys Firmware) | ™

Also, do you think this configuration will dynamically switch from one router to the other based on the signal strength? Then it will act just like an Ethernet switch to provide the extra Ethernet ports that you need.

Reply Helpful Thread reply – more options Link to this Post. Help answer questions Learn more. Mar 7, 4: To create this article, 17 people, some anonymous, worked to edit and improve it over time.