It’s always fun to see short arcs fire up! This page was last updated: The bulb and driver are soldered together, using LOTS of isolation actually way more than on the picture Ready, set, But if I were you I would try to find out which arc gap the original lamp for this philips ballast has and run it with such a lamp. With the older 3-pin connectors this usually means connecting two pins don’t know which one for this ballast.

Uploader: Arashirr
Date Added: 13 January 2008
File Size: 6.42 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 61055
Price: Free* [*Free Regsitration Required]

It’s always fun to see short arcs fire up!

The ballast, when defective, usually causes a problem with the lamp not turning on. Last edited by 3zuli; at If so, then the heavy cable LampLighter ignitor connector should directly plug into the lamp housing and chances are, it’s DC so polarity does matter.

This should be a complete driver with all the electronics required to start and operate the bulb this guy made it work: Is it that you want the focal point of the lens to be where the focal point of the ellipse is, and you want the diameter big enough to c0/0 all the light that diverges from the ellipsoidal focal point?


Buy Products Online from China Wholesalers at

Flashlights and Parts WTS: My UHP project quick beamshot Might serve well as inspiration for searching the hard facts about your ballast, lamp and possible power supply combo. I also identified the input polarity.

Bookmarks Bookmarks Digg del. Heres the Link if you need some ideas. Image resizer by SevenSkins. The lamp also causes this problem. One reverse polarity ignition pulse might be enough to destroy the lamp.

A picture will significantly help in locating the item. There are possibly several different versions for That means a huge success Now I need to experiment with the 3-pin wire and the rectifier circuit It appears and sounds like according to your post, that these two components came from different sources and are not matched.

But they are both from the same manufacturer and both are rated for W, so now the only thing I need to do is to connect them together connectors aren’t the same.

Your posting is not clear on this. See each listing for international shipping options and costs.

EUC 150 C/00 Projector Ballast Lamp Driver Lighting

My UHP project Congratulations! I would definitely not connect 020 amount of AC power to the white input connector, I think you’ll destroy the board and lamp.


It doesn’t have any tripod screw, lmp the only way to make it tripod-mounted is to use some binding straps along with some aluminium mounting plate Well, it works The 3-wire cable might also be a feedback circuit to keep the lamp operating at a precise output. Front Page What’s New? My UHP project A eux measurement at 5m or 10m would be nice Pulled from a working television that was no longer needed in household works great.

My UHP project – The 8€ Short Arc

Genuine Samsung Factory Service Part. I usually see capacitors large and multipletoroidal coils, FET’s on heat sinks and other parts. My UHP project The qualifier: Again, what’s the polarity of this connector?

All times are GMT Thanks guys for help. It is warranted against DOA see bellow. So the choice is yours.