Continue with the Laminator Routine Maintenance Procedures listed below. Range 1 to 40 Increase Value The index pointer moves toward the lower letters see the adjustment procedure. Continue to rotate the guard until it is free from the retaining slot. Page When the tabs on the chassis are clear of the openings, lift the chassis and control board out of the base. Obtain a new download an updated firmware update update file. Skip to main content.

Uploader: Mazular
Date Added: 9 August 2010
File Size: 15.85 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 42850
Price: Free* [*Free Regsitration Required]

Remove the ribbon cartridge and cleaning roller. Heater Lift Motors The polarity is shown above.

Diagnostics will not run without the print driver. The Magnetic Write Head contains a small coil of wire wrapped around a semicircular iron core. Your request will be sent to datacarr local sales representative for an immediate follow up with you.

Lamination Process The card is moved toward the laminator position at normal transport speed, as the laminate foil is registered.

This item is no longer available.

June Updated for Daatacard compliance. Rear Drive Roller If present, partially remove the smart card contact carrier: HID Corporation and is shown here for educational purposes.

Follow-up Procedure Datacwrd several test cards to ensure there are no transport problems. To remove the solenoid link, rotate it 90 degrees and pull it off the rocker. As North America’s largest full-service identification and security solutions provider, we offer extremely competitive prices, as well as local on-site service and support.


Trade your CP80 in for credit towards vatacard new ID card printer. Have one to sell? Twist the blade to pry the carrier out of the mounting tab.

Cleaning Rocker Assembly Cleaning Rocker Assembly When replacing the rocker assembly, it is a good idea to replace the springs as well. Replacement printheads for use in datacard desktop card printers 2 pages.

Datacard Cp80 Plus ID Card & Driver License Printer Topaz Signature Fingerprint

This value is best modified in the printer driver interface under the Edge to Edge tab. Lift the corner only the corner of the guard past the edge of the datwcard. The flipper will rotate and re-register at the handoff position.

Setting Laminator Values Laminator Values parameters. Page Simultaneously pull back on the transport chassis and forward on the input hopper. For additional information, see the Global Shipping Program terms and conditions – opens in a new window or tab.

Monochrome ribbons for use in datacard desktop card printers 2 pages. The pulley’s flange is permanently adhered to the pulley. Add to cart – Best Offer: Unplug the magnetic stripe head and encoder cables from the magnetic stripe board.


Page Enter key to move to the next field. Removal And Replacement Chapter 6: The driving circuitry for the duplex clutch is located datacqrd the duplex interface board.

Datacard CP80 Plus

Printhead Cam Using a screwdriver, pry the flag-side of the cam out of the transport chassis. If the error continues, replace the main control board. Users also appreciate that this Datacard printer can send data about the cards back to any computer for auditing purposes, as well as locking parts of the device so that it is difficult to use in case of theft. Feed the first heater wire back through the heater slide.

Recent sales price provided by the seller You save: This amount is subject to change until you make payment.