Don’t forget that step. Anyway, it would be a good time to test your issues with a current daily compat-wireless driver as there are some new patches in it and still time to get stuff into oneiric. Hm, I have iwconfig working here with compat-wireless on current stable mainline kernel 3. Install the testing firmware package from http: They hope these examples will help you to get a better understanding of the Linux system and that you feel encouraged to try out things on your own. What is the actual data rate you get from iperf or some other speed measurement tool. Great step by step.

Uploader: Darg
Date Added: 2 October 2015
File Size: 41.71 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 78480
Price: Free* [*Free Regsitration Required]

Newer generation Ralink hardware is now supposed to be supported by the rt2x00 project’s drivers rtpci and rtusb.

D-LINK DWL G and Linux | Toys for the desk!

To activate it build your kernel e. Thank you so much!

I’ve tried to remove and insert the driver again but it dosen’t help. Sorry, the oneiric image I used previously was an old one, downloaded on So the md5sums are not printed.

D-LINK DWL G122 and Linux

Linux – Wireless Networking This forum is for the discussion of wireless networking in Linux. Run the following two commands and post their output so that we have enough information about what you have tested: I’m starting downloading ubuntu now, and I have a doubt, my computer needs a USB stick with dwl-h122 network to achieve.


Hm, I have iwconfig working here with compat-wireless on current dwl-g1222 mainline kernel 3. Hi, I need some real help I’ve downloaded the driver from serialmonkey.

My lsmod shows rt73usb, rt2xusb and rt2x00lib Does anybody know how must I install this USB device? On Fri, Jun 10, at So, before following these instructions, make sure to have my same USB key.

D-Link DWL-G122 rev C1

Upgraded to natty on 5 days ago dmi. Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter. Please visit this page to clear all LQ-related cookies.

Don’t forget that step. Your email address will not be published. Click Here to receive this Uguntu Guide absolutely free. Great step by step.

As you can see, it looks for a directory named build, but there no such directory. Have you tried blacklisting rtsta and going through a shutdown – boot cycle before testing to check against interference of some kind?


To make the check you can also plug the key into your Linux system, then run from a terminal:. I will try the V3.

For more advanced trainees it can be a desktop reference, and a collection of the base knowledge needed to proceed with system and network administration. I have just installed Slackware Your last ping test looks good again, but can you tell whether power saving is on or off without iwconfig? Wolfgang Kufner wolfgangkufner wrote on Join our community today! I’m sorry, but after reboot things are not working well.

Cell 01 – Address: Hi Wolfgang, I’ve tried this config with kernel v3rc7 however when I try to compile compact-wireless I get the following error:.

Changed in linux Ubuntu: A bit kerne build has shown up: I think the first test was incorrect because I used the sta driver and the unload command wluload did not remove it so I got both driver working which means it’s useless. If you run this command, you should see somthing like this:.