AP5001 AP5101 DRIVER

Pas de ligne vide avant Windows Registry Editor Version 5. When enabled pads are tristated and the input path is disabled. When set to 1 it indicates that irregular or missing pulses are detected in the TMDS clock. An interrupt has been generated. Windows XP Windows version: When set to 1 it indicates a that an Audio packet has been received with an uncorrectable error. When a message has been received into buffer 2 this bit is set.

Uploader: Saramar
Date Added: 22 December 2009
File Size: 15.1 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 41737
Price: Free* [*Free Regsitration Required]

Used only for a 2nd receiver Dual-link Mode. This field is a signed value. However, no responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other rights of third parties that may result from its use. This measurement is valid only when the vertical filter has locked.

If the message transmission is sill in the ‘signal free time’ stage the message transmission will be terminated. This configuration is recommended.

Releases Related to Delinquent Filings, 2017 Archive

Maximum difference to switch out of free run is lines. Contains bit C3 coefficient for the C channel. The default value corresponds to MHz.

  ASUS F3E NETWORK DRIVER

Windows Registry Editor Version 5. Initial Preliminary Version Rev. Refer to Hardware Manual for more details.

APB10 LEM [LEM], APB10 Datasheet

Choisis ta session et non la session Administrateur. Refer to the Hardware Manual for more details on the Channel Status data readbacks. If an interrupt event that has been enabled for the INT2 pin has occurred this bit will be set to 1.

PNF” 15 Dec This is the main I2C power-down control. INI” 20 Dec LOG” 3 Jan When set to 1 it indicates that irregular or missing pulses are detected in the TMDS clock.

That is the version in the background port measurement blocks. It sets the audio mutes if the Audio PLL unlocks. Normal operation 1 – Override the deep color mode extracted from the General Control Packet.

The frequency must be specified in MHz divided by When set to 1 it indicates that a CEC frame has been received and is waiting to be read in receiver frame buffer 0. The seven LSBs represent the fractional part of the saturation value.

  CASSANDRA CALE JAVA DRIVER DOWNLOAD

Do not use A4[ CGMSD bit goes high to indicate a valid checksum. Maximum difference to switch out of free run is 31 lines.

Interrupts for INT1 are set via the interrupt 1 mask bits. When set to 1 it ap501 that a CEC frame has been received and is waiting to be read in receiver frame buffer 1.

Maximum difference to switch ap510 of free run is 15 lines. This bit is used to support extended data range modes.

Divide readback by 2 to get number of lines xxxxxxxxxxxxxx – The total number of half lines in the VSync Front Porch of Field 0.

This mode can only be used in multi channel modes.