AIC3106 LINUX DRIVER

For technical support please post your questions at http: It supports various flash devices. The full device tree file can be found here: The commit for this change in Linux stable tree is a patch. This page has been accessed , times.

Uploader: Zulurg
Date Added: 14 November 2011
File Size: 44.98 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 39404
Price: Free* [*Free Regsitration Required]

AMx has a bit watchdog timer which can be used to reset the hardware in case of a software fault. Please note as of Wednesday, August 15th, this wiki has been set to read only.

This section indicates the power measured for all power rails when system is in suspended state via suspend-to-ram. This section indicates the power measured for all power rails at various OPPs selected via cpufreq. The change in the resistance ratio marks the location on the touchscreen. If watchdog device node is closed before timeout also reboot won’t happen. The I2C driver is implemented as a serial driver. Green colored box in the table below means that the particular boot mode is supported on the device in the release.

  MDM 5614PM3C DRIVER

Supports the socket and ai3106 system calls in accordance with Linux architecture. The features include clock control at module level, multiple power and voltage aic310 etc.

The commit for aci3106 change in Linux stable tree is a00e patch. The cpuidle framework helps in saving power during the idle state. The commit for this change in Linux stable tree is 27f39e5 patch.

Add fixed regulator ai3c106. Test setup is available here. The definition of idle at Linux prompt is as per the tables shown below. If you are a TI Employee and require Edit ability please contact x from the company directory.

Most Device Tree configuration will pertain to the machine layer, which is where the codec and McASP drivers are glued together. Thus, overall SPI performance reported above is lower than what auc3106 be obtained using a 48 MHz clock.

The MMC driver is implemented as a block driver.

Linux Archives – Page of – Linux Kernels

U-Boot bootdelay variable is set to 0. Measurements were taken while Linux was idle at command prompt. This driver is used as a utility by other drivers for data transfer. This section indicates the power measured for all power rails when system is in Standby state. For further information or to report any problems, contact http: This page was last modified on 28 Linnuxat Total Power Sum of all Rails.

  GARMIN IQUE-M5 USB DRIVER

Posts on Linux 4.4

Enable analog audio support The […]. The commit for this change in Linux stable tree is 79a4e64 patch. This is an opportunity to save power. AMx devices provides a rich set of power management features. The commit for this change in Linux stable tree is abf patch. In addition to adding the corresponding Device Tree entries listed below, you must ljnux edit the kernel configuration so that the codec and McASP drivers are built by the kernel.

Time from reset to “Login: The commit for this change in Linux stable tree is 2bee patch.